Dynasty C&D Battery UPS6-620 & UPS6-620FR have been replaced by the UPS6-620MR

Click here to purchase the replacement UPS6-620MR Battery from our online store at batteriesasap.com

UPS6-620
Valve Regulated Lead Acid Battery
for UPS standby power applications
6V 200 AH @ 20 hr rate,
6V 620 watts/cell @ 15 min. rate

UPS6-620
Valve Regulated Lead Acid Battery
for UPS standby power applications
6V 200 AH @ 20 hr rate,
6V 620 watts/cell @ 15 min. rate

FEATURES

Flame-arresting one-way pressure-relief vent for safety and long life.
Thermally welded case-to-cover bond to eliminate leakage.
Absorbent Glass Mat (AGM) technology for efficient gas recombination of up to 99% and freedom from electrolyte maintenance.
Computer-generated grid design optimized for high power density.
UL-recognized component.
Multicell design for economy of installation and maintenance.
Can be mounted in any orientation.
Not restricted for air transport – Complies with IATA/ICAO Special Provision A67.
Not restricted for surface transport – Classified as non-hazardous material as related to DOT-CFR Title 49 parts 171-189.
Computer designed lead, low calcium alloy grid for minimal gassing and ease of recycling.
Case and cover available in both standard and flame retardant polypropylene.
Flame retardant polypropylene case and cover compliant with UL 1778 (optional).

* All dimensions in inches and (millimeters). All dimensions are for reference only. Contact a C&D Representative for complete dimensional information.

UPS6-620 - Specifications
Cells Per Unit	Voltage Per Unit	Weight	Electrolyte	Maximum Discharge Current	Short Circuit Current	Ohms Imped. 60 Hz
3	6.42	72 lbs. 33 kg .	Absorbed H₂SO₄ SG = 1.300	800 Amps	4350 Amps @ 0.1 sec.	0.0015 Ohms
Capacity			620 watts per cell at the 15 minute rate to 1.67 volts per cell at 77°F (25°C).
			200 Ah @ 20 hr. rate to 1.75 volts per cell @ 77°F (25°C).
			170 Ah @ 10 hr. rate to 1.80 volts per cell @ 20°C (68°F).
Operating Temperature Range			Discharge; -40°F (-40°C) to +160°F (71°C)		Charge; -10°F (-23°C) to +140°F (60°C). (with temperature compensation)
Nominal Operating Temperature Range			+74°F (23°C) to +80°F (27°C).
Float Charging Voltage			6.75 to 6.90 VDC/unit Average at 77°F (25°C).
Recommended Maximum Charging Current Limit			C/5 amperes (40 amperes @ 100% depth of discharge) @ 20 hour rate.
Equalization and Cycle Service Charging Voltage			7.2 to 7.4 VDC/unit Average at 77°F (25°C).
Maximum AC Ripple (Charger)			0.5% RMS or 1.5% P-P of float charge voltage recommended for best results.
			Maximum voltage allowed = 1.4% RMS (4% P-P).
			Maximum current allowed = 9 amperes RMS (C/20).
Self Discharge			Dynasty UPS batteries may be stored for up to 6 months at 77°F (25°C) and then a freshening charge is required. For higher temperatures the time interval will be shorter.
Accessories			Inter unit connectors, racks and cabinet systems are available.
Terminal			"L" terminal with 0.28" clearance hole to accept 0.25" (6mm) bolt.
Terminal Hardware Initial Torque			75 in.-lbs. (8.5 N-m).
Terminal Hardware Annual Retorque			60 in.-lbs. (6.8 N-m).

Note:

Batteries to be mounted with 0.5 in (1.25 cm) spacing minimum and free air ventilation. Specifications subject to change without notification.

Dynasty C&D Battery UPS6-620

Call for pricing

UPS6-620 6 Volt 200 Amp Hour Battery Dynasty C&D Battery Johnson Control

Home Batteries UPS Technology Emergency Lighting Battery Chargers Factory Links Contact Us Buy Batteries Online

Power Factor Inc.

2526 Manana Dr – Suite 102 – Dallas – Texas – 75220

800-706-7009

Our Goal, NO DISSATISFIED CUSTOMERS!

Since 1995

While every precaution has been taken to ensure accuracy and completeness in this literature, Power Factor Inc. assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions. Specifications subject to change without notice.
All names referred to are trademarks or registered trademarks of their respective owners.

Dynasty C&D Battery UPS6-620 & UPS6-620FR have been replaced by the UPS6-620MR

UPS6-620 Valve Regulated Lead Acid Battery for UPS standby power applications 6V 200 AH @ 20 hr rate, 6V 620 watts/cell @ 15 min. rate

UPS6-620
Valve Regulated Lead Acid Battery
for UPS standby power applications
6V 200 AH @ 20 hr rate,
6V 620 watts/cell @ 15 min. rate