Dynasty C&D Battery Johnson Control UPS12-140

Click Here to Buy On-Line

UPS 12-140
Valve Regulated Lead Acid Battery
for UPS standby power applications
12V 33 AH @ 20 hr rate,
12V 140 watts/cell @ 15 min. rate

UPS 12-140
Valve Regulated Lead Acid Battery
for UPS standby power applications
12V 33 AH @ 20 hr rate,
12V 140 watts/cell @ 15 min. rate

FEATURES

	Flame-arresting one-way pressure-relief vent for safety and long life.
	Thermally welded case-to-cover bond to eliminate leakage.
	Absorbent Glass Mat (AGM) technology for efficient gas recombination of up to 99% and freedom from electrolyte maintenance.
	Computer-generated grid design optimized for high power density.
	UL-recognized component.
	Multicell design for economy of installation and maintenance.
	Can be mounted in any orientation. Upright, side or end mounting recommended.
	Not restricted for air transport – Complies with IATA/ICAO Special Provision A67.
	Not restricted for surface transport – Classified as non-hazardous material as related to DOT-CFR Title 49 parts 171-189.
	Computer designed lead, low calcium alloy grid for minimal gassing and ease of recycling.
	Case and cover available in both standard and flame retardant polypropylene.
	Flame retardant polypropylene case and cover compliant with UL 1778 (optional).

*All dimensions in inches and (millimeters). All dimensions are for reference only. Contact a C&D Representative for complete dimensional information.

UPS12-140- Specifications
Cells Per Unit	Voltage Per Unit	Weight	Electrolyte	Maximum Discharge Current	Short Circuit Current	Ohms Imped. 60 Hz
6	12.84	27 lbs. 12 kg.	Absorbed H₂SO₄ SG = 1.300	500 Amps	2500 Amps @ 0.1 sec.	0.0060 Ohms
Capacity			140 watts per cell at the 15 minute rate to 1.67 volts per cell at 77°F (25°C).
			32 Ah @ 20 hr. rate to 1.75 volts per cell @ 77°F (25°C).
			29 Ah @ 10 hr. rate to 1.80 volts per cell @ 20°C (68°F).
Operating Temperature Range			Discharge; -40°F (-40°C) to + 160°F (71°C).		Charge; -10°F (-23°C) to +140°F (60°C) (with temperature compensation)
Nominal Operating Temperature Range			+74°F (23°C) to +80°F (27°C)
Float Charging Voltage			13.5 to 13.8 VDC/unit Average at 77°F (25°C).
Recommended Maximum Charging Current Limit			C/5 amperes (6.5 amperes @ 100% depth of discharge) @ 20 hour rate.
Equalization and Cycle Service Charging Voltage			14.4 to 14.8 VDC/unit Average at 77°F (25°C).
Maximum AC Ripple (Charger)			0.5% RMS or 1.5% P-P of float charge voltage recommended for best results.
			Maximum voltage allowed = 1.4% RMS (4% P-P).
			Maximum current allowed = 1.3 amperes RMS (C/20).
Self Discharge			Dynasty UPS batteries may be stored for up to 6 months at 77°F (25°C) and then a freshening charge is required. For higher temperatures the time interval will be shorter.
Accessories			Inter unit connectors, racks and cabinet systems are available.
Terminal			"L" terminal with 0.28" clearance hole to accept 0.25" (6mm) bolt.
Terminal Hardware Initial Torque			40 in.-lbs. (4.5 N-m).
Terminal Hardware Annual Retorque			32 in.-lbs. (3.48 N-m).

Note:

Batteries to be mounted with 0.5 in (1.25 cm) spacing minimum and free air ventilation. Specifications subject to change without notification.

Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140 Dynasty C&D Battery Johnson Control UPS12-140

Call for pricing

UPS12-140 12 Volt 33 Amp hour Johnson control Dynasty C&D Battery

Home - 9 Power Problems - Problems with Power - APC - Powerware - MinuteMan - MGE - Liebert - Batteries - Chargers / Rectifiers - Emergency Lighting - Service - Factory Links

Power Factor Inc.

2526 Manana Dr – Suite 102 – Dallas – Texas – 75220

NO DISSATISFIED CUSTOMERS!

Since 1995

While every precaution has been taken to ensure accuracy and completeness in this literature, Power Factor Inc. assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions. Specifications subject to change without notice.
All names referred to are trademarks or registered trademarks of their respective owners.

Dynasty C&D Battery Johnson Control UPS12-140

UPS 12-140 Valve Regulated Lead Acid Battery for UPS standby power applications 12V 33 AH @ 20 hr rate, 12V 140 watts/cell @ 15 min. rate

UPS 12-140
Valve Regulated Lead Acid Battery
for UPS standby power applications
12V 33 AH @ 20 hr rate,
12V 140 watts/cell @ 15 min. rate